Hello. In the latest firmware of the adapter, it is possible to enable diagnostics via the KWP1281 protocol using the VTP291 command. Question: what command can I use to return the adapter to its original state?

Здравствуйте. В последней прошивке адаптера есть возможность включить командой VTP291 диагностику по протоколу  KWP1281. Вопрос: какой командой могу вернуть адаптер в исходное состояние?

(04-11-2025, 09:33 AM)Сергей Wrote: Hello. In the latest firmware of the adapter, it is possible to enable diagnostics via the KWP1281 protocol using the VTP291 command. Question: what command can I use to return the adapter to its original state?

Здравствуйте. В последней прошивке адаптера есть возможность включить командой VTP291 диагностику по протоколу  KWP1281. Вопрос: какой командой могу вернуть адаптер в исходное состояние?

Hello.
If you need to return the device to factory settings, you can long press the button on the device and release it when all the LEDs light up at the same time, wait for 5 seconds and power the device back up again
You can refer to this video: https://www.vgatemall.com/u_file/fileUpl...151252.mp4

To reset the device to its factory settings, hold down the power button for 5 seconds until all of the lights on the device light up simultaneously, then release the button. Turn the device back on.
io games